choose by category
Or Search Below
Husqvarna Core Drill
DS800
Contact Us
Currently Available
Features
- Drill holes up to 16" (extra spacer required)
- 1" to 14" bit capacity standard
- 42" long, precision ground and plated 2-7/8" square column reduces flex for more accurate drilling
- Watercooled 3 speed gearbox for optimal drilling performance and longer service intervals.
- The LED indicator shows the load of the machine, allowing the operator to always drill at maximum pressure, for best performance.
- To facilitate drilling during the initial stages, as well as during the operation, a button can be pressed to reduce the speed by half. This feature is useful when making a starter hole or cutting through reinforcements.
- If the motor runs at too high a load for a long period, it will start to pulsate. If the load is not reduced the motor will shut off, to prevent overheating. Elgard™ significantly increases the machine’s service life.
- An electronic current limiter for softer starts. Full speed is reached about two seconds after the switch is turned on.
- Water hose can be turned 180°.
Equipment specifications
DS 800 Low Speed
Motor
Single Phase - Electric
Voltage
115V
Power
4.4 hp / 3,300 W / 30 amps
Bit Capacity
14 in
Connection
1-1/4"-7 thread
Loaded RPM
170/380/650
No Load RPM
240/530/900
Travel Length
25-1/2 inch
Weight
122 lbs
DS 800 High Speed
Motor
Single Phase - Electric
Voltage
115V
Power
3 hp / 2,300 W / 20 amps
Bit Capacity
14 in
Connection
1-1/4"-7 thread
Loaded RPM
350/780/1340
No Load RPM
440/970/1670
Travel Length
25-1/2 inch
Weight
122 lbs